- Annealing
- Heating steel and cooling it slowly to soften it, relieve stress and make it easier to machine.
- Billet / Bloom / Slab
- Semi-finished cast shapes. Billets are small square sections, blooms larger, slabs wide and flat.
- Buy America
- U.S. rules requiring that steel used in federally funded projects be melted and manufactured domestically.
- Carburizing
- Adding carbon to the surface of a low-carbon steel (such as 8620) so it can be hardened into a wear-resistant case over a tough core.
- DFARS
- Defense Federal Acquisition Regulation Supplement. Its specialty-metals clause requires certain metals in defense items to be melted or produced in the U.S. or a qualifying country.
- Hardenability
- How deeply a steel will harden when quenched. Alloying elements like chromium, molybdenum and nickel increase it.
- Heat
- One batch of steel from a single melt. Its heat number ties every piece back to the same chemistry and test results.
- Hot-work vs. cold-work
- Hot-work tool steels (such as H13) keep their strength at high temperature; cold-work grades (such as D2) are built for wear and strength at room temperature.
- Mill Test Report (MTR)
- The certified document for a heat: chemistry, mechanical properties and the standards it meets.
- Normalizing
- Heating above the critical temperature and cooling in air to refine grain structure and even out properties.
- Precipitation hardening (PH)
- Strengthening by aging at moderate temperature, which forms fine particles in the steel. 17-4 PH is the classic example.
- Quench & temper (Q&T)
- Hardening by rapid cooling, then reheating to trade some hardness for toughness.
- Rockwell hardness (HRC)
- A common hardness scale for hardened steel, measured by indentation depth.
- Tempering
- Reheating hardened steel to a lower temperature to reduce brittleness and set final hardness.
Have a grade, a print or a problem?
Send it over. A metallurgist will come back with how we'd make it.